3030226 Rev. D 5-23 Routine Maintenance
9. The RO is ready for rinsing. Press START RINSE NOW. The RO will begin a flush
process to remove the residual sanitizer. Verify that the feed and
TDS/conductivity readings decrease as the rinse process is performed. Do not
connect any fittings to the Y connector.
10. The RO will operate in a rinse mode where the internal tank is being filled and
drained rinsing the RO.
11. After 30 STEPS (i.e. rinses) are complete, the EXIT button will be visible
indicating that the operator can EXIT. If the exit button is not pressed, the RO
will continue to flush for a total of 50 STEPS. If the operator presses EXIT or
allows the RO to complete all of the rinse steps, the RO will return to the
Chemical or Heating Operations selection screen.
12. Press EXIT.
To Next Page
Loading...
