Masimo Rad-97 Operator's Manual

Rad-97 Chapter 3: Setting Up
www.masimo.com 42 Masimo
Attach NIBP Cuff
1. Connect the cuff to the patient hose.
2. Connect the opposite end of the patient hose to the NIBP Nib located on the front
of Rad-97. See Chapter 6: Noninvasive Blood Pressure (NIBP) on page 109.
Masimo Kite
Masimo Kite Software Application is a passive monitoring interface to Point-of-Care (POC)
Masimo medical devices (Rad-97 for example) that co-exist under the same Wi-Fi network.
Kite remotely displays system and parameter status reported by the POC device on a separate
monitor.
Rad-97 must be on the same network as Kite.
Note: If the device is not on the same network, it can be added, but Kite will not be able to
connect it to view the parameters monitored by that device until both Kite and the device are
connected to the same network.
To add Rad-97 to Kite to view parameter status, refer to the Masimo Kite Software Application
Operator's Manual.
Third-Party Devices
Third-party devices can be connected to Rad-97 through Bluetooth communication. For more
information, including how to connect a device to Rad-97, see Chapter 8: Third-Party Devices
on page 121.

Masimo Rad-97 Specifications

General

Display Size	7 inches
SpO2 Accuracy	±2% (70-100%)
Pulse Rate Accuracy	±3 bpm
Perfusion Index Range	0.02% to 20%
Pleth Variability Index Range	0% to 100%
SpO2 Range	0% to 100%
SpHb Range	0 to 25 g/dL
SpCO Range	0% to 40%
Battery Type	Rechargeable lithium-ion
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Humidity Range	10% to 95% non-condensing
Display	Color touchscreen
Connectivity	Wi-Fi, Ethernet, Bluetooth
Power Supply	100–240 VAC, 50–60 Hz
Battery Life	Approximately 4 hours
Measurements	SpO2, Pulse Rate, Perfusion Index, Pleth Variability Index, SpHb, SpOC, SpMet, SpCO
Pulse Rate Range	25 to 240 bpm
HbCO Range	0-99%
MetHb Range	0-99%
SpMet Range	0-99%
Data Storage	Internal memory
Alarms	Audible and visual alarms for all parameters