Matrix mvBlueFOX3 User Manual

Luminance: Selects the Luminance LUT.
LUTEnable - - -
0,
1
Activates the selected LUT.
LUTIndex 0 255 1 -
Control the index (offset) of the coefficient
to access in the selected LUT.
LUTValue 0 1023 1 -
Returns the Value at entry LUTIndex of
the LUT selected by LUTSelector.
LUTValueAll - - - -
Accesses all the LUT coefficients in a
single access without using individual
LUTIndex.
mvLUTType - - -
Direct,
Interpolated
Describes the type of LUT used.
Direct: The user can define an output
value for each input value of the LUT.
Interpolated: The user can define the
output values for equidistant nodes in the
LUT. Linear interpolation is used to
determine the output values for input
values that lie in between the given nodes.
mvLUTInputData - - -
Bayer,
RGB
Describes the data the LUT is operating
on
Bayer: The LUT is operating on raw Bayer
data (i.e. before debayering)
RGB: The LUT is operating on RGB data
(i.e. after debayering)
mvLUTMapping - - -
map_8To12,
map_10To10
Describes the mapping of the LUT
map_8To12: The LUT maps 8 bit input
data to 12 bit output data.
map_10To10: The LUT maps 10 bit input
data to 10 bit output data.
Feature Name Min Max Inc
Valid
Values
Documentation
TestControl A category for Test Control features.
TestPendingAck 0 INT_MAX 1 -
Tests the device's pending
acknowledge feature. When this
feature is written, the device waits a
time period corresponding to the
value of TestPendingAck before
acknowledging the write. (ms)
TestEventGenerate@i - - - - Generates a Test Event.
21 Appendix A.2 CMOS specific camera / sensor data
1433

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English