Figure 3: ChunkData
The task of resetting the counter at the beginning of the acquisition can be done by setting the reset
property accordingly. Of course is this all independent whether the camera is acquiring images in
triggered or continuous mode.
18.9.3 Using the standby mode
18.9.3.1 System requirements
"Firmware version" at least "1.6.188.0"•
"mvIMPACT Acquire driver version" at least "2.10.1"•
Using mvDeviceStandbyTimeout:
"Firmware version" at least "2.12.406.0"•
"mvIMPACT Acquire driver version" at least "2.17.1"•
18.9.3.2 Introduction
It is possible to switch the mvBlueFOX3 into a power down mode (standby) either
by changing the property "mvDevicePowerMode" to "mvStandby" or•
by enabling the automatic power down mode by setting the property
"mvDeviceStandbyTimeoutEnable" to "bTrue" and by specifying the timeout using the
property "mvDeviceStandbyTimeout".
•
The latter one will switch the camera to the power down mode as soon as no register was read (i.e.
neither the camera is used nor images were acquired) during a specified time period (in seconds)
specified by the property "mvDeviceStandbyTimeout".
18 Use cases
242
To Next Page
Loading...
Need help?
General