Matrix mvBlueFOX3

Figure 2: wxPropView - Setting acquisition of a number of images started by an external signal
A rising edge at line 4 will start the acquisition of 20 images.
18.2.2 Recording sequences in the camera
18.2.2.1 Introduction
Beside the mvPretrigger, there are two further mv Acquisition Memory Mode available:
mvRecord
which uses frame rate and trigger settings.
1.
mvPlayback
which disregards the frame rate and trigger settings and outputs the images as fast as
possible (throttling by "bandwidth setting").
2.
To use mvRecord, just
set mv Acquisition Memory Mode to mvRecord.1.
Start the camera with "Use" and "Acquire".2.
The camera will record mv Acquisition Memory Max Frame Count images into the memory.
18 Use cases
151