You can use either Continuous or a trigger mode as Acquisition Mode in "Setting
-> Base -> Camera -> GenICam -> Acquisition Control". However, if an
external (line) trigger will have to be used, it is absolutely required that the external trigger is
always present. During a trigger interruption, controlling or communication to the camera is
not possible!
21.4.3.4 Frame rate calculator (area mode)
Frame rate calculator
Mode:
Overlapping exposure and readout (default)
Exposure and readout without overlapping
Image width: pixels
Image height: pixels
Exposure time: us
Frame rate (max): 1/s
ExposureTime > FrameTime
21.4.3.5 Frame rate calculator (linescan mode)
Frame rate calculator
Mode:
Global shutter (free run)
Rolling shutter (free run)
Triggered
Color:
Gray scale
Color
Exposure time: us
Frame rate (max): 1000/s
21.4.4 Device Feature And Property List
21.4.4.1 Gray scale version
Feature
Name
Min Max Inc
Valid
Values
Documentation
ProductFeatures
This list has been created with driver version '2.17.3'
and Firmware version '2.14.488.0'. This does NOT
imply that all these features will only be available
since these versions. They might be available in
previous ones as well.
Feature Name Min Max Inc
Valid
Values
Documentation
Camera
This list contains features to
control the device
ImageRequestTimeout_ms 0
ms
INT_MAX 1
ms
- Defines the timeout for the
request in ms. Once the
timeout has elapsed the
request object is returned to
the user even if no data has
21 Appendix A.2 CMOS specific camera / sensor data
1578
To Next Page
Loading...
Need help?
General