Matrix mvBlueFOX3 User Manual

Figure 1: wxPropView - Code Generation section
To generate code first of all an appropriate file name should be selected. In order to prevent file
name clashes the following hints should be kept in mind when thinking about a file name:
If several devices from different families or different vendors shall later be included into an
application each device or device family will need its own header file thus either the files
should be organized in different subfolders or must have unique names.
•
If a device shall be used using different interface layouts again different header files must be
generated.
•
If only a single device family is involved but 2 interface layouts will be used later a suitable file name
might be "mvIMPACT_acquire_GenICam_Wrapper_DeviceSpecific.h".
For a more complex application involving different device families using the GenICam interface
layout only something like this might make sense:
mvIMPACT_acquire_GenICam_Wrapper_MyDeviceA.h•
mvIMPACT_acquire_GenICam_Wrapper_MyDeviceB.h•
mvIMPACT_acquire_GenICam_Wrapper_MyDeviceC.h•
...•
Once a file name has been selected the code generator can be invoked by executing the "int
GenerateCode()" method:
18 Use cases
146

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English