come from
mvUser: States where the
tap balancing calibration
data does come from
GainSelector - - -
AnalogAll,
DigitalAll
Selects which Gain is
controlled by the various
Gain features.
AnalogAll: Gain will be
applied to all analog
channels or taps.
DigitalAll: Gain will be
applied to all digital
channels or taps.
Gain 0.000 18.000 - -
Controls the selected gain
as an absolute physical
value in dB. This is an
amplification factor
applied to the video
signal. (dB)
GainAuto - - -
Off,
Continuous
Sets the automatic gain
control (AGC) mode. The
exact algorithm used to
implement AGC is
device-specific.
Off: Gain is User
controlled using Gain.
Continuous: Gain is
constantly adjusted by the
device.
mvGainAutoUpperLimit 0.000 18.000 - -
The upper limit of the gain
in auto gain mode.
mvGainAutoLowerLimit 0.000 18.000 - -
The lower limit of the gain
in auto gain mode.
mvGainAutoAverageGrey 0 100 1 -
Common desired average
grey value (in percent)
used for Auto Gain
Control(AGC) and Auto
Exposure Control(AEC).
mvGainAutoHighlightAOI - - - Off,
On
Highlight auto control AOI
to check AOI settings.
Switch off for normal
operation.
Off: Highlight auto control
AOI to check AOI settings.
Switch off for normal
operation.
On: Highlight auto control
AOI to check AOI settings.
21 Appendix A.2 CMOS specific camera / sensor data
1602
To Next Page
Loading...