EasyManuals Logo

Matrix mvBlueFOX3 User Manual

Matrix mvBlueFOX3
1974 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1787 background imageLoading...
Page #1787 background image
On: Enable the selected trigger.
TriggerSource - - - Line4,
Line5,
Timer1Start,
Timer2Start,
Timer1End,
Timer2End,
Timer1Active,
Timer2Active,
mvLogicGateOR1Output,
mvLogicGateOR2Output,
mvLogicGateOR3Output,
mvLogicGateOR4Output,
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3,
Counter1End,
Counter2End,
Counter3End,
Counter4End,
Counter1Active,
Counter2Active,
Counter3Active,
Counter4Active,
Software,
Off
Specifies the internal signal or
physical input Line to use as the
trigger source. The selected trigger
must have its TriggerMode set to On.
Line4: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Line5: Specifies which physical line
(or pin) and associated I/O control
block to use as external source for
the trigger signal.
Timer1Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2Start: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer2End: Specifies which Timer
signal to use as internal source for
the trigger.
Timer1Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
Timer2Active: Specifies the internal
signal or physical input Line to use
as the trigger source.
mvLogicGateOR1Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR2Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR3Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
mvLogicGateOR4Output: Specifies
the internal signal or physical input
Line to use as the trigger source.
UserOutput0: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput1: Specifies which User
Output bit signal to use as internal
source for the trigger.
UserOutput2: Specifies which User
Output bit signal to use as internal
source for the trigger.
21 Appendix A.2 CMOS specific camera / sensor data
1779

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Matrix mvBlueFOX3 and is the answer not in the manual?

Matrix mvBlueFOX3 Specifications

General IconGeneral
BrandMatrix
ModelmvBlueFOX3
CategoryDigital Camera
LanguageEnglish