Matrix mvBlueFOX3

DigitalTap3,
DigitalTap4
All: Black Level will be
applied to all channels
or taps.
DigitalAll: Selects which
Black Level is
controlled by the
various Black Level
features.
DigitalTap1: Selects
which Black Level is
controlled by the
various Black Level
features.
DigitalTap2: Selects
which Black Level is
controlled by the
various Black Level
features.
DigitalTap3: Selects
which Black Level is
controlled by the
various Black Level
features.
DigitalTap4: Selects
which Black Level is
controlled by the
various Black Level
features.
BlackLevel 0.000 100.000 - -
Controls the analog
black level as an
absolute physical value.
This represents a DC
offset applied to the
video signal.
BalanceRatioSelector - - -
Red,
Blue,
Green
Selects which Balance
ratio to control.
Red: Balance Ratio will
be applied to the red
channel.
Blue: Balance Ratio will
be applied to the blue
channel.
Green: Some grey
sensors have different
gains for adjacent
pixels. Similar to white
balancing this can be
used to slow down
different gains.
BalanceRatio 0.063 16.000 - - Controls ratio of the
21 Appendix A.2 CMOS specific camera / sensor data
1846