Matrix mvBlueFOX3 User Manual

Counter signal to use as internal
source for the trigger.
Counter3End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter4End: Specifies which of the
Counter signal to use as internal
source for the trigger.
Counter1Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter2Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter3Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Counter4Active: Specifies the
internal signal or physical input Line
to use as the trigger source.
Software: Specifies that the trigger
source will be generated by software
using the TriggerSoftware command.
Off: Specifies the internal signal or
physical input Line to use as the
trigger source.
TriggerActivation - - -
RisingEdge,
FallingEdge,
AnyEdge,
mvNone
Specifies the activation mode of the
trigger.
RisingEdge: Specifies that the trigger
is considered valid on the rising edge
of the source signal.
FallingEdge: Specifies that the
trigger is considered valid on the
falling edge of the source signal.
AnyEdge: Specifies that the trigger is
considered valid on the falling or
rising edge of the source signal.
mvNone: Specifies the activation
mode of the trigger.
TriggerDelay 0.000 UINT_MAX - -
Specifies the delay in microseconds
(us) to apply after the trigger
reception before activating it. (us)
TriggerSoftware@i - - - -
Generates an internal trigger.
TriggerSource must be set to
Software.
mvAcquisitionFrameRateLimitMode - - - mvDeviceLinkThroughput,
mvDeviceMaxSensorThroughput
Controls the calculation of the
maximum frame rate.
mvDeviceLinkThroughput: Uses the
highest possible frame rate
depending on bandwidth and sensor
21 Appendix A.2 CMOS specific camera / sensor data
1931

Matrix mvBlueFOX3 Specifications

General

Brand	Matrix
Model	mvBlueFOX3
Category	Digital Camera
Language	English