Matrix mvBlueFOX3 - Page 1950

DigitalTap3,
DigitalTap4
channels or taps.
AnalogTap1: Analog
gain will be applied to
Tap 1.
AnalogTap2: Analog
gain will be applied to
Tap 2.
AnalogTap3: Analog
gain will be applied to
Tap 3.
AnalogTap4: Analog
gain will be applied to
Tap 4.
DigitalTap1: Digital gain
will be applied to Tap 1.
DigitalTap2: Digital gain
will be applied to Tap 2.
DigitalTap3: Digital gain
will be applied to Tap 3.
DigitalTap4: Digital gain
will be applied to Tap 4.
Gain 0.000 28.000 - -
Controls the selected
gain as an absolute
physical value in dB.
This is an amplification
factor applied to the
video signal. (dB)
GainAuto - - -
Off,
Continuous
Sets the automatic gain
control (AGC) mode.
The exact algorithm
used to implement AGC
is device-specific.
Off: Gain is User
controlled using Gain.
Continuous: Gain is
constantly adjusted by
the device.
mvGainAutoUpperLimit 0.000 28.000 - -
The upper limit of the
gain in auto gain mode.
mvGainAutoLowerLimit 0.000 0.000 - -
The lower limit of the
gain in auto gain mode.
mvGainAutoAverageGrey 0 100 1 -
Common desired
average grey value (in
percent) used for Auto
Gain Control(AGC) and
Auto Exposure
Control(AEC).
mvGainAutoHighlightAOI - - - Off,
On
Highlight auto control
AOI to check AOI
21 Appendix A.2 CMOS specific camera / sensor data
1942