Bouncing is the tendency of any two metal contacts in an electronic device to generate multiple
signals as the contacts close or open; now debouncing is any kind of hardware device or software
that ensures that only a single signal will be acted upon for a single opening or closing of a contact.
To address problems that can arise from these kinds of trigger signals MATRIX VISION offers
debouncing filters at the digital inputs of a device.
The debouncing filters can be found under "Setting -> Base -> Camera -> GenICam -> Digital I/O
Control -> LineSelector" (red box in Figure 1) for each digital input:
Figure 1: wxPropView - Configuring Digital Input Debounce Times
18 Use cases
229
To Next Page
Loading...