Matrix mvBlueFOX3

Resets the device to its
power up state. After reset,
the device must be
rediscovered.
DeviceRegistersStreamingStart@i - - - -
Prepare the device for
registers streaming without
checking for consistency.
DeviceRegistersStreamingEnd@i - - - -
Announce the end of
registers streaming. This will
do a register set validation
for consistency and activate
it. This will also update the
DeviceRegistersValid flag.
mvDeviceStatusLEDEnable - - -
0,
1
If enabled, the color of the
LED changes depending on
the state of the camera.
Otherwise the LED is Off.
mvDevicePowerMode - - -
mvActive,
mvStandby
Selects the device power
mode.
mvActive: Puts the device to
power-active mode.
Afterwards features will be
restored to the values they
had before entering power
down mode. LUT values are
not restored.
mvStandby: Puts the device
in power-saving mode. In this
mode the device will only
consume up to 20 percent of
its normal power
consumption.
mvDeviceStandbyTimeoutEnable - - -
0,
1
If enabled, the device
switches to standby after a
configurable time if no
register is read.
mvDeviceStandbyTimeout 10 60 1 -
Defines the time in seconds
after which the device
automatically switches to
standby if no register is read.
DeviceLinkSelector 0 0 1 -
Selects which Link of the
device to control.
DeviceLinkSpeed 0 INT_MAX 1 -
Indicates the speed of
transmission negotiated on
the specified Link. (Bps)
DeviceLinkThroughputLimitMode - - - Off,
On
Controls if the
DeviceLinkThroughputLimit
20 Appendix A.1 Pregius CMOS specific camera / sensor data
363