camera.
DeviceClockFrequency INT_MIN INT_MAX - -
Returns the frequency of the
selected Clock. (Hz)
mvDeviceClockFrequency - - - kHz_74250
Clock frequency of the image
sensor of the camera.
kHz_74250: Clock frequency
of the image sensor of the
camera.
DeviceFirmwareVersion - - - -
Version of the firmware in the
device.
mvDeviceFirmwareBuildDate - - - -
The build time and date of
the firmware
DeviceScanType - - - Areascan
Scan type of the sensor of
the device.
Areascan: 2D sensor.
mvDeviceSensorName - - - -
Shows the name of the
sensor.
mvDeviceSensorColorMode - - - BayerMosaic
Shows color mode of the
sensor.
BayerMosaic: Shows color
mode of the sensor.
mvDeviceFPGAVersion - - - -
Shows version number of the
FPGA.
DeviceReset@i - - - -
Resets the device to its
power up state. After reset,
the device must be
rediscovered.
DeviceRegistersStreamingStart@i - - - -
Prepare the device for
registers streaming without
checking for consistency.
DeviceRegistersStreamingEnd@i - - - -
Announce the end of
registers streaming. This will
do a register set validation
for consistency and activate
it. This will also update the
DeviceRegistersValid flag.
mvDeviceStatusLEDEnable - - -
0,
1
If enabled, the color of the
LED changes depending on
the state of the camera.
Otherwise the LED is Off.
mvDevicePowerMode - - - mvActive,
mvStandby
Selects the device power
mode.
mvActive: Puts the device to
power-active mode.
Afterwards features will be
20 Appendix A.1 Pregius CMOS specific camera / sensor data
408
To Next Page
Loading...