Matrix mvBlueFOX3 - Page 453

Line1: Index of the physical line
and associated I/O control block
to use.
Line2: Index of the physical line
and associated I/O control block
to use.
Line3: Index of the physical line
and associated I/O control block
to use.
Line4: Index of the physical line
and associated I/O control block
to use.
Line5: Index of the physical line
and associated I/O control block
to use.
mvLineCaps INT_MIN INT_MAX 1 - Invisible
LineMode - - - Output
Controls if the physical Line is
used to Input or Output a signal.
Output: The selected physical line
is used to Output an electrical
signal.
LineStatus - - -
0,
1
Returns the current status of the
selected input or output Line.
LineSource - - - Off,
ExposureActive,
UserOutput0,
UserOutput1,
UserOutput2,
UserOutput3,
Timer1Active,
Timer2Active,
Counter1Active,
Counter2Active,
Counter3Active,
Counter4Active,
AcquisitionActive,
FrameActive,
mvReadOutActive,
LineActive,
mvExposureAndAcquisitionActive,
FrameTriggerWait,
mvTemperatureOutOfRange,
mvLogicGateOR1Output,
mvLogicGateOR2Output,
mvLogicGateOR3Output,
mvLogicGateOR4Output,
mvExposureActive
Selects which internal acquisition
or I/O source signal to output on
the selected Line. LineMode must
be Output.
Off: Line output is disabled
(Tri-State).
ExposureActive: Device is doing
the exposure of a Frame (or
Line).
UserOutput0: The chosen User
Output Bit state as defined by its
current UserOutputValue.
UserOutput1: The chosen User
Output Bit state as defined by its
current UserOutputValue.
UserOutput2: The chosen User
Output Bit state as defined by its
current UserOutputValue.
UserOutput3: The chosen User
Output Bit state as defined by its
current UserOutputValue.
Timer1Active: The chosen Timer
is in active state.
Timer2Active: The chosen Timer
is in active state.
Counter1Active: The chosen
counter is in active state
20 Appendix A.1 Pregius CMOS specific camera / sensor data
445