Connector (camera side): SAMWOO SNH-10-12 (RPCB) or equivalent
Plug (matching cable plug): Hirose HR10A-10P-12S (01) or equivalent
8.2.1.1 Pinning of KS-BCX-HR12
Pin.
CON 1 mvBlueFOX3-1xxx |
Signal
CON 1 mvBlueFOX3-2xxx |
Signal
CON 2 cutted cable |
Color
1 GND (for VDC) black
2 not connected V
IN
+12V to +24V brown
3 DigOut3 (wxPropView numbering: line3) red
4 Opto DigIn0 (line4) orange
5 DigOut2 (line2) yellow
6 DigOut0 (line0) green
7 Opto DigIn GND blue
8 RS232_RX violet
9 RS232_TX gray
10 +OUT_V+ white
11 Opto DigIn1 (line5) white-black
12 Opto DigOut1 (line1) white-brown
Main connector shield main shield
Color assignment following international code for UL wiring.
8.2.1.2 Power Supply
The mvBlueFOX3 is bus powered. Anyway, it is possible to power the mvBlueFOX3-2 externally
with following specs:
Input voltage range:
12 .. 24V DC (typical)♦
min. 10V♦
max. 30V♦
•
The power supply is protected against
burst (EN 61000-4-4)♦
surge (EN 61000-4-5) and♦
polarity inversion♦
•
internal short circiuit protection by 1.5A slow blow fuse•
The USB power cannot be accessed via the I/O connector (this is prevented by a diode).
"Typ. Power Consumption @ 5V"
Model
Power consumption (+/-
10%)
Unit
-1012b 2.13 W
-1100 2.18 W
8 Technical data
57
To Next Page
Loading...
Need help?
General