to all digital channels or taps.
DigitalTap1: Digital gain will
be applied to Tap 1.
DigitalTap2: Digital gain will
be applied to Tap 2.
DigitalTap3: Digital gain will
be applied to Tap 3.
DigitalTap4: Digital gain will
be applied to Tap 4.
Gain 0.000 48.000 - -
Controls the selected gain as
an absolute physical value in
dB. This is an amplification
factor applied to the video
signal. (dB)
GainAuto - - -
Off,
Continuous
Sets the automatic gain
control (AGC) mode. The
exact algorithm used to
implement AGC is
device-specific.
Off: Gain is User controlled
using Gain.
Continuous: Gain is
constantly adjusted by the
device.
mvGainAutoUpperLimit 0.000 48.000 - -
The upper limit of the gain in
auto gain mode.
mvGainAutoLowerLimit 0.000 0.000 - -
The lower limit of the gain in
auto gain mode.
mvGainAutoAverageGrey 0 100 1 -
Common desired average
grey value (in percent) used
for Auto Gain Control(AGC)
and Auto Exposure
Control(AEC).
mvGainAutoHighlightAOI - - -
Off,
On
Highlight auto control AOI to
check AOI settings. Switch off
for normal operation.
Off: Highlight auto control AOI
to check AOI settings. Switch
off for normal operation.
On: Highlight auto control AOI
to check AOI settings. Switch
off for normal operation.
mvGainAutoAOIMode - - - mvFull,
mvCenter,
mvUser
Common AutoControl AOI
used for Auto Gain
Control(AGC), Auto Exposure
Control(AEC) and Auto White
Balancing.
mvFull: Common AutoControl
20 Appendix A.1 Pregius CMOS specific camera / sensor data
782
To Next Page
Loading...