the User Output register.
UserOutputValue - - -
0,
1
Sets the value of the bit selected
by UserOutputSelector.
UserOutputValueAll INT_MIN INT_MAX 0x1 -
Sets the value of all the bits of the
User Output register. It is subject
to the UserOutputValueAllMask.
UserOutputValueAllMask INT_MIN INT_MAX 0x1 -
Sets the write mask to apply to
the value specified by
UserOutputValueAll before writing
it in the User Output register. If
the UserOutputValueAllMask
feature is present, setting the user
Output register using
UserOutputValueAll will only
change the bits that have a
corresponding bit in the mask set
to one.
Feature Name Min Max Inc Valid Values Documentation
mvFrameAverageControl
Contains features to control
the frame averaging engine.
mvFrameAverageEnable - - -
0,
1
Enables the frame averaging
engine.
mvFrameAverageMode - - -
mvNTo1,
mvNTo1Sum
Sets the frame average
operating mode.
mvNTo1: Sets the frame
average operating mode.
mvNTo1Sum: Sets the frame
average operating mode.
mvFrameAverageFrameCount 2 14 1 -
Here you specify the frame
count used for the calculation
of the frame average.
Feature Name Min Max Inc Valid Values Documentation
SequencerControl
A category for the
Sequencer Control
features.
SequencerMode - - -
Off,
On
Controls if the sequencer
mechanism is active.
Off: Disables the
sequencer.
On: Enables the
sequencer.
SequencerConfigurationMode - - - Off,
On
Controls if the sequencer
configuration mode is
active.
Off: Disables the
20 Appendix A.1 Pregius CMOS specific camera / sensor data
895
To Next Page
Loading...