Matrox Extio 3 Series - Using OSD Command Shortcuts

Matrox Extio 3 Series – User Guide 19
2 In the Configure language settings screen that appears, select the OSD interface
language from the
Language drop-down list.
3 Click Close .
Using OSD command shortcuts
You can use keyboard mnemonics for command shortcuts in the OSD user interface. Press and hold
the
ALT key to see the underlined letter that corresponds to a command shortcut. Connect ,
Disconnect , Wake-on LAN , and Close are some command examples in the receiver OSD.
Note: The language you change to will override the default language set in Matrox Extio
Central Manager.
When you make the change, it takes effect immediately (there is no need to reboot or
restart the device).
Only the last change made is retained. You cannot have user-specific language settings. For
example, once you log out, the next user to log in will see the OSD interface in the language
you changed it to. The next user can change it again to a different language if required. In
this case, when you log in the next time, you would have to change the settings to your
preferred language again.