EasyManua.ls Logo

Mazda 2006 MX-5 - Brake Fluid Pressure Sensor Construction; Brake Fluid Pressure Sensor Function; Dsc Indicator Light Function; Steering Angle Sensor Construction

Mazda 2006 MX-5
492 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DYNAMIC STABILITY CONTROL
04–15–17
04–15
BRAKE FLUID PRESSURE SENSOR FUNCTION
E5U041543774N01
The brake fluid pressure sensor detects the fluid pressure from the master cylinder and transmits it to the DSC
HU/CM.
End Of Sie
BRAKE FLUID PRESSURE SENSOR CONSTRUCTION
E5U041543774N02
The brake fluid pressure sensor is integrated with the DSC HU/CM. Therefore if there is any malfunction of the
brake fluid pressure sensor, replace the DSC HU/CM.
End Of Sie
STEERING ANGLE SENSOR FUNCTION
E5U041566120N01
The steering angle sensor, located on the combination switch, detects the steering angle degree and the
neutral position, and transmits these to the DSC HU/CM via CAN lines.
Warning
The following circumstances will cause the stored initialization value of the steering angle sensor
to be cleared. This may possibly cause an accident due to the DSC becoming inoperative. Always
refer to the Workshop Manual and properly perform the initialization procedure for the steering
angle sensor so that the DSC operates properly.
Negative battery cable disconnection
Steering angle sensor connector disconnection
Fuse (ROOM 15A) removal
Wiring harness disconnection between battery and steering angle sensor connector
Note
If the initialization procedure for the steering angle sensor has not been performed, when the ignition
switch is turned to the ON position, the DSC indicator light illuminates and the DSC OFF light flashes to
warn of a malfunction.
End Of Sie
STEERING ANGLE SENSOR CONSTRUCTION
E5U041566120N02
The steering angle sensor, integrated with the
combination switch body, has a sensor unit
straddling a disc that moves together with the
steering mechanism. Therefore, if there is any
malfunction of the steering angle sensor, replace
the combination switch body.
End Of Sie
DSC INDICATOR LIGHT FUNCTION
E5U041555430N01
The DSC indicator light, built into the instrument cluster, informs the driver of the following vehicle conditions.
DSC is operating (vehicle side-slip)
TCS is operating (drive wheel slipping)
End Of Sie
SENSOR UNIT
DISC
CHU0415S015

Table of Contents

Other manuals for Mazda 2006 MX-5

Related product manuals