By replacing the defective part, McConnel shall consider itself free from any other expenses borne by the
Dealer and the Dealer's Customer, for instance alleged damage, either present or future, such as lost
earnings, conventional penalties, etc.
Ordinary and extraordinary maintenance must be performed in accordance with the instructions contained in
this manual. For all cases not included and for every type of assistance, contact McConnel directly by
registered letter or fax, even in the case of agreements made by telephone. McConnel shall not be held
responsible for any delays or missed interventions. McConnel shall not be held responsible for any damage
or malfunctions due to technical operations carried out on the machine by unauthorised personnel.
1.6 - RESPONSIBILITIES
McConnel considers itself exempted from all liability and obligations for accidents involving personal injuries
or damage to property which may occur due to:
• Failure to observe the instructions given in this manual to run, operate and perform maintenance on the
machine;
• Abrupt actions or incorrect manoeuvres when operating or performing maintenance on the machine;
• modifications made to the machine without prior written authorisation from McConnel;
• Any other events that cannot be considered normal and correct use of the machine.
In any case, whenever the user blames the accident on a defect of the machine, it is necessary to
prove that the consequent damage was a main and direct consequence of such defect.
Any tampering or the use of non-original spare parts will create the conditions for voiding the warranty
and put the operator's safety at risk.
• For repairs or maintenance always make exclusive use of original spare parts.
• McConnel declines all liability for any damage that may be caused as a result of non-
compliance with the above.
• The machine is guaranteed according to the contractual agreements entered into
upon sale.
• The warranty, however, will not apply if the rules and instructions of use contained
in this manual have not been complied with.
1.7 - PERMITTED USES
RC40 is a machine manufactured to be used by professional personnel. The machine is a self- propelled
radio-controlled vehicle that can be used in the agricultural sector, with the possibility of attaching different
tools to the front lifting equipment, as well as in the forestry sector.
RC40 (hereinafter referred to as “machine”) and the tools are not toys, but a PROFESSIONAL MACHINE.
Always respect the conditions of use specified by the producers of the machine. The machine is suitable for
performing flail mowing operations at a speed of up to 4-5 km/h, depending on the conditions of the ground
and the type and condition of material to be cut (length, whether dry or wet, density etc.) and on slopes
having a maximum inclination of 55°.
This machine is generally used during daylight hours. If, under exceptional circumstances, it has to be used
at night or in conditions of reduced visibility, an auxiliary lighting system must be used. Operate in daylight
or with artificial lights which guarantee a visibility of at least 100 metres.
To Next Page
