• Stickers are applied to the machine to ensure safer use. They must be
replaced if they are no longer legible.
• The operator must never be an occasional worker but must have some
experience with this type of machine.
• If the direct view of the work area from the driving position is not
sufficient, the
operator must be assisted by an expressly appointed person.
• Check the condition and operation of any part subject to wear on a monthly
basis:
(pins, valves, piping etc.). Where necessary, replace them with original parts.
• Never, under any circumstances, tamper with the hydraulic system and in
any case do not remove the seal from the valves as this would invalidate the
warranty. To adjust the valves, contact an authorised workshop.
• Excessive heating of the oil causes damage to the gaskets of the hydraulic
circuit and deterioration of the fluid itself. Heating is caused by lamination of
the oil through the maximum pressure valve. For this reason, avoid extended
operation with the jacks at the end of the stroke.
• It is also necessary to check that the machine emergency button and remote
control stop button are working correctly. If the emergency or stop buttons
are damaged, the machine must not be started up or its operation must be
stopped immediately.
• The machine user is responsible for all property damage or personal injuries
caused by machine operation.
• Maintenance, cleaning, adjustments or similar operations on any part of the
machine or interchangeable equipment connected to it are strictly forbidden
when the machine is moving. Any maintenance, cleaning or adjustments
must always be performed with the engine off.
• It is forbidden to remove or alter the guards protecting moving parts or hot
surfaces
of the machine, or interchangeable equipment connected to it.
To Next Page
