3.2 - GENERAL PRECAUTIONS
• It is mandatory to read and follow the instructions indicated in the use and maintenance manual
before performing any operation or manoeuvre with the machine. It is too late to do so while
working. Improper use or an incorrect manoeuvre can result in serious damage to people or
property;
• The operators and maintenance technicians must be familiar with the machine, in particular they
must know the dangers deriving from incorrect use or incorrect repairs;
• Before starting, carry out all the checks on the machine and equipment such as:
○ Operation;
○ Accident prevention regulations;
○ Guards;
• Even when using the machine correctly, stones or other objects can be projected far away.
Therefore, there must be nobody within the danger zone (100 metres). Be very careful when
working near roads or buildings;
• Before starting the work, always check the integrity of the tools and of all guards; if damaged or
missing, replace them;
• Make sure that nobody can involuntarily start the machine during checks and repairs.
• Do not wear loose clothing;
• Never transport anyone on the machine;
• Never carry persons on the cutting head or on any other mounted equipment;
• Do not stand near the machine until the equipment is at completed standstill;
• Before each start-up, make sure that there are no people and/or animals nearby;
• Before leaving the machine, proceed as follows:
○ Park the machine on a flat surface.
○ Reduce the rpm of the engine before turning it off. Press the remote-control red button and turn
the ignition key to the “O” position.
○ Remove the ignition key and take the remote control away with you.
• Immediately replace any lost or worn warning plates or pictograms;
• Never underestimate or ignore safety regulations;
• Go to an authorised workshop if the safety devices are not working.
• Keep the remote control out of the reach of unauthorised personnel and especially children.
3.2.1 - SAFETY WARNINGS
The machine has been designed and built according to the technical requirements in force for
operations such as mowing grass, hedges, maintenance of green areas of roadsides, slopes,
canals, water drainage, etc. Observe the laws, provisions, requirements, ordinances and
directives in force for such machines.
The materials used and the pieces of equipment, as well as the production procedures, quality
guarantee and checks meet the highest safety and reliability standards.
Use the machine for the purposes specified in this user manual, operating it with the due diligence
and carry out accurate maintenance and revisions as envisaged to obtain the highest performance,
continuous operation and ensure a long service life of the machine.
To Next Page
