6.3.1 - CONNECTION BETWEEN MACHINE AND TRANSMITTER
To make a connection between the machine and transmitter, proceed as follows:
1. Arm the emergency stop button (A) on the machine, by turning it clockwise.
2. Turn the ignition key to the “I” position (B), by turning it one turn clockwise.
3. Arm the emergency stop button (6) on the remote control, by turning it clockwise.
4. Turn the ignition key to the “I” position (10), by turning it one turn clockwise. Wait a few
seconds to allow the machine to check the active functions.
5. Press the remote control/receiver connection search button (8) to enable the connection
between the transmitter and receiver.
6. When the connection occurs, an audible warning will be emitted (horn).
• If for any reason the radio control loses the connection signal between the
transmitter and receiver, the machine stops immediately and the engine revs
will be reduced to idle speed.
• The connection between the transmitter and receiver must be re-established in
order to continue.
• When the connection is lost, it cannot be re-connected automatically and a
new connection has to be established.
To Next Page
Loading...