McConnel ROBOCUT2 RC40 - 6.4.2 Warning Lights

57
McCONNEL
HANGE MAPPING PAGE (OPTIONAL)
6.4.2 - WARNING LIGHTS
The following indicator lights/warnings may appear on the display according to the faults that
may arise.
HORN
STOPS
ENGINE
CAUSE
SOLUTION
YES
NO
Fuel tank less than 1/4 full
Top up
NO
NO
The parking brake is on
Move the left-hand side joystick for-
wards/backwards
YES
NO
Hydraulic oil level less than 2/3
Top up and/or check for leaks
NO
YES
Oil level too low
Top up and/or check for leaks
NO
NO
The alternator does not charge
the battery
Check the alternator and/or contact
customer care
NO
YES
The air filter is clogged
Clean the filter elements
NO
YES
The hydraulic oil filter is clogged
Replace the cartridge
NO
NO
Glow plug preheating is active
(optional)
Wait for the indicator light to turn off and
start the machine
NO
YES
Engine oil pressure too low
Check the engine oil level and/or the
engine oil sensor
NO
YES
Engine stop
Release the emergency button
NO
YES
Coolant temperature > 110°C
Clean the radiator and/or check the
level of coolant
NO
NO
Low coolant level
Top up
NO
NO
Change mode
---