9.5.4 - COOLANT REPLACEMENT
• The coolant must be replaced every 1000 working hours or after 1 year.
• Before removing the cap, loosen it slowly until the first stop to relieve the
pressure inside.
• The coolant must be chosen very carefully; refer to the table in section 9.4.2.
• Danger of burns due to very hot coolant!
• The cooling system is under pressure! If pressurised coolant spurts out, it
may cause serious injuries.
• Before removing the cap, loosen it slowly until the first stop to relieve the
pressure inside.
• Remove the fuel filler cap only when it has cooled down enough to be
touched with the bare hand.
• When handling fuel or coolant, do not smoke or work near heat sources or
sparks.
• Dispose of spilled coolant in accordance with the relative standards and do not
allow it to penetrate the ground.
• The improper disposal of waste can threaten the environment and the
ecological system. For disposal or correct recycling of waste, contact the
relevant agencies.
• The protective agents of the cooling system must be ordered from McConnel
partners.
• Never use the engine without coolant, not even for a short time!
To Next Page
Loading...