EasyManua.ls Logo

McConnel ROBOCUT2 RC40 - 6.3.2 Starting the Engine

Default Icon
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39
McCONNEL
6.3.2 - STARTING THE ENGINE
ATTENTION
Observe the safety instructions;
Only start the machine outside, not in closed environments to avoid the
danger of carbon monoxide poisoning; a toxic gas which can kill in a matter
of minutes. This gas is INVISIBLE, TASTELESS and ODOURLESS. Even if the
exhaust fumes are not inhaled, it is still possible to be exposed to carbon
monoxide. If you feel ill or weak when using the product, switch the engine off
and go outside IMMEDIATELY. Contact a doctor. Carbon monoxide poisoning
may have occurred.
The machine can be started with the following means:
Key in the machine;
Remote control;
To start the engine using the key:
1. Turn the ignition key (A) to the “I” position, by turning it one turn clockwise. Wait a few seconds
to allow the machine to check the active functions.
2. Turn the ignition key (A) to the “II” position, by turning it one turn clockwise. Release the ignition
key.
WARNING
If the engine is started using the key it is no longer possible to connect with the
remote control!
ATTENTION
The starter motor must only be operated continuously for a maximum of 30
seconds. Trying to start the engine for too long will damage the starter motor.
BURNT OUT STARTER MOTORS ARE NOT COVERED BY THE WARRANTY.

Table of Contents

Related product manuals