• To start the engine using the remote control, proceed as follows:
1. Make the connection between the machine and transmitter (see section 6.3.1).
2. Wait a few seconds for the active functions check.
3. Press the starter switch (7) up on the remote control; once the engine has started,
release the switch.
• If for any reason the radio control loses the connection signal between the
transmitter and receiver, the machine stops immediately, and the engine revs
will be reduced to idle speed.
• The connection between the transmitter and receiver has to be re-established
in order to continue.
• When the connection is lost, it cannot be re-connected automatically and a
new connection has to be established.
• The starter motor must only be operated continuously for a maximum of 30
seconds. Trying to start the engine for too long will damage the starter motor.
• BURNT OUT STARTER MOTORS ARE NOT COVERED BY THE WARRANTY.
To Next Page
Loading...