McHale HS2000 Round Bale Wrapper
49
3. Press Display Down (button 4) four times to select the Contrast menu.
4. Use Display Up and Display Down (buttons 1 and 4) to select the appropriate
setting and press Enter (button 3) to save the new setting.
Continuous cycle
When the continuous cycle is switched on, it allows the wrapper to tip off the bale at
the end of wrapping without any input from the operator. Continuous cycle can only be
selected if the trailed sequence is set.
To access Continuous Cycle settings:
1. Press Display Down (button 4) three times.
2. Press Enter (button 3) once to access the Operator Setup menu.
3. Press Display Down (button 4) five times to select the Continuous Cycle
settings.
4. Use Display Up and Display Down (buttons 1 and 4) to select the appropriate
setting and press Enter (button 3) to save the new setting.
Drawbar/steer (does not apply to newer machines)
This is used to select whether the operator wants the drawbar or steering active on
the bottom two buttons of the control unit (buttons 17 and18). The drawbar is adjusted
to place the wrapper at the correct working position either behind the tractor or the
baler. The safety bar is first placed in the working position and the drawbar left/right
menu selected where the buttons will adjust the drawbar. Alternatively the handle can
be used on the machine control valve. When using valve handle to adjust drawbar,
slowly deflect the valve handle as the machine will move. On steering machines,
adjustments to the drawbar will make it necessary to readjust the zero set position of
the drawbar angle sensor.
Zero set (does not apply to newer machines)
The zero position (centre position) of the drawbar sensor may be set from within this
menu. The control box is switched to manual and ‘self steer’ switched off. The
wrapper wheels must first be set to the straight ahead position as shown on the
control box display, (using the steering buttons to centre the indicator on the wheel
angle display). The drawbar is next adjusted by using the control box buttons or the
lever handle on the wrapper to place the wrapper in line with the baler. The
combination is next driven forward a short distance in a straight line to allow the
wrapper to find its position behind the baler, when the machines are in alignment Zero
Set is selected, and enter is pushed. The display shows “New Zero Set”. This “new“
centre position for the drawbar sensor is now stored in the control box memory. Self
steer may now be switched on. Should the wrapper be attached to another baler or
the drawbar adjusted this calibration must be done again.
To Next Page
Loading...
