CSP−HMI−3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI−3 Book TOC ]
96 Contents
Page i
Revision 14
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright © 1999−2016 by MD Helicopters, Inc.
TABLE OF CONTENTS
Para/Figure/Table Title Page
96-00-00 Electrical Power A......................................................
Maintenance Practices 201.......................................................
1. Description and Operation 201.................................................
2. Miscellaneous DC Main Power and Control 201..................................
3. Electrical System - Fault Isolation 201..........................................
Figure 201. Electrical Equipment - Cabin Location 202.........................
Table 201. Troubleshooting Electrical System 203.............................
4. Electrical Connectors 205......................................................
5. Repair/Replacement of Connectors 205..........................................
A. External Power Receptacle Replacement 206..................................
B. Replacement of Terminal Blocks and Terminal Block Contact Tips 206...........
6. Maintenance of Electrical Bonding Connections 206..............................
7. Electrical Wiring and Harnesses 206............................................
A. Electrical Symbols 207.......................................................
B. Electrical Maintenance - Wiring, Electrical Bonding
and Wiring Harnesses 207...................................................
C. Wire Harness Replacement 207...............................................
8. Air/Ground Switch S522 207...................................................
A. Air/Ground Switch S522 Replacement 208.....................................
B. Air/Ground Switch S522 Adjustment 208......................................
Figure 202. Air/Ground Switch Adjustment 209................................
Table 202. Wire Identification 210............................................
Figure 203. Identification and Replacement of Terminal
Block Modules (Sheet 1 of 4) 211...................................
Figure 204. Electrical Symbols 215...........................................
Figure 205. Component Location (Sheet 1 of 6) 216.............................
Inspection/Check 601.............................................................
1. Module Inspection 601.........................................................
Figure 601. Grommet Damage Criteria 601....................................
2. Connector and Accessories Inspection 601.......................................
Figure 602. Accept/Reject Criteria for Connector Defects (Sheet 1 of 6) 602.......
3. Wiring Inspection 605..........................................................
A. Wire Harness Inspection 605.................................................
Figure 603. Drip Loops and Downward Attachment of Wired Lugs 606...........
B. Single Wire and Shielded Wire Damage Limitations 607........................
Table 601. Conductor Damage Limits 607.....................................
Table 602. Broken Shield Strand Allowance 607................................
To Next Page
Loading...
