MD Helicopters 369D - Revision 14

CSP−HMI−3
MD Helicopters, Inc
.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI−3 Book TOC ]
Page iv
Revision 14
96 Contents
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright © 1999−2016 by MD Helicopters, Inc.
TABLE OF CONTENTS (Cont.)
Para/Figure/Table Title Page
96-05-10 Heavy Duty Battery (17 Amp, 20 Cell) A.................................
Maintenance Practices 201.......................................................
1. Description and Operation 201.................................................
2. Battery Handling and Servicing Precautions 201.................................
3. Troubleshooting 201...........................................................
4. Battery Servicing 201..........................................................
5. Battery Charging 201..........................................................
6. Cleaning, Repair and Maintenance 201..........................................
7. Battery Temperature Sensors 201...............................................
Figure 201. Arrangement and Busing 202.....................................
8. Battery Replacement 202......................................................
Figure 202. Battery Installation 203..........................................
Initial Installation 901............................................................
1. Heavy Duty Battery Initial Installation 901.....................................
A. Preparation for Installation 901..............................................
B. Inboard and Outboard Access Door Support Modification 901...................
Figure 901. Inboard and Outboard Door Support Modification 902...............
C. Installation of Forward Battery Support Assembly 903.........................
D. Installation of Aft Battery Support Assembly 903..............................
Figure 902. Battery Support Installation 904..................................
E. Installation of Terminal Board Support Bracket and Relocation of Terminal Board .....
905
F. Voltage Adjustment 905.....................................................
G. Installing Battery Wire Harness 905..........................................
Figure 903. Terminal Board Support Bracket Installation 906...................
H. Installing Battery and Completing Installation 907............................
I. Weight and Balance 907.....................................................
Table 901. Weight and Balance Data 907......................................
96-10-00 DC Generation A........................................................
Maintenance Practices 201.......................................................
1. Description and Operation 201.................................................
2. DC Generation - Fault Isolation 201............................................
3. Generator Control Unit (GCU) 202..............................................
A. Generator Control Unit (GCU) Replacement 202...............................
B. Adjustment of Installed Generator Control Unit (GCU) 202.....................
Figure 201. Generator Control Unit (GCU) Removal/Installation 202............
Table 201. Recommended Voltage Settings 203.................................