CSP-HMI-3 MD Helicopters, Inc.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI−3 Book TOC ]
[ Chapter 96 TOC ]
Page 902
Revision 8
96-05-10
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright © 1999−2016 by MD Helicopters, Inc.
G96-0012A
0.40 IN. (1.016 MM)
(TYP) (4 PLCS)
0.82 IN. (2.0828 MM)
(TYP) (2 PLCS)
0.40 IN. (1.016 MM)
(TYP) (4 PLCS)
SADDLE
(NOTES 1, 2)
CLIP
(NOTE 3)
CLIP
(NOTE 3)
SADDLE
(NOTES 1, 2)
NOTES:
1. REMOVE SADDLES AND APPLY PRIMER TO HOLES; LEAVE HOLES OPEN.
2. RELOCATE SADDLES AS SHOWN.
3. REMOVE CLIPS AND APPLY PRIMER HOLES; LEAVE HOLES OPEN.
Figure 901. Inboard and Outboard Door Support Modification
To Next Page
Loading...
