CSP-HMI-3 MD Helicopters, Inc.
MAINTENANCE MANUAL
[ Main Menu ]
[ HMI−3 Book TOC ]
[ Chapter 97 TOC ]
Page 2
Revision 12
97-01-00
The information disclosed herein is proprietary to MD Helicopters, Inc.
Neither this document nor any part hereof may be reproduced or transferred to
other documents or used or disclosed to others for manufacturing or any other
purpose except as specifically authorized in writing by MD Helicopters, Inc.
Copyright © 1999−2016 by MD Helicopters, Inc.
plug of a headset. A headset connector is
attached to the free end of the coiled cord. The
headset connector mates with the jack of a
headset cable assembly (Ref. Figure 3). A clip
is provided on the side of the case for attach
ment to clothing. Consult the optional equip
ment table for specific applications (Ref. Table
202, Sec. 01-00). Consult the ICS wiring
diagrams in this manual for wiring informa
tion (Ref. Sec. 97-02-00, 97-04-00 or
97-06-00).
NOTE: The modified CE394K3-174 adaptor is
for use with the KMA 24H audio control
panel, to avoid MIC LO ground loop (MIC
LO is grounded inside the KMA 24H). The
modified adaptor otherwise functions the
same as the unmodified adaptor.
C. Headset Cable Assemblies
(Ref. Figure 3) Headset cable assemblies
provide the electrical interface between the
crew's headsets and the ICS control panels.
The cable assemblies are installed on the
upper part of the canted bulkhead, with the
jacks located conveniently for the crew to plug
in their headsets. Consult the optional
equipment table for specific applications (Ref.
Table 202, Sec. 01-00-00). Consult the ICS
wiring diagrams in this manual for wiring
information (Ref. Sec. 97-02-00, 97-04-00 or
97-06-00).
To Next Page
Loading...
