Page 1 - 4 TA3H, TA3SH & TA3.5SH
1. Introduction
1.6 Warranty Registration
Your dealer will have registered you as the owner with Mecalac at the time of sale. Should you
have any queries please consult your dealer in the first instance.
1.7 Warranty Terms and Conditions
Full terms and conditions of the machines warranty will be found on the warranty certificate
incorporated in or accompanying this manual.
1.8 Service and Replacement Parts Enquiries
Please state the vehicle type and the Vehicle Identification Number (VIN) when making enquiries
or orders and in all written correspondence.
1.9 Official Documents European Community Only
(1) CE mark
The Machinery Safety directive is intended to harmonise all the machinery safety regulations
throughout the community so that there will be no technical barriers to trade.
Compliance with the essential safety requirements of the EEC directives 2006/42/EC
(machinery), 2000/14/EC (Noise) and 2004/108/EC, permits companies to CE mark their
products.
The directive affects almost every equipment supplier and user in the community and in
particular, applies to this type of machine.
The regulations require that potential hazards from machinery are properly addressed and
guarded against.
The EC declaration of conformity is a requirement of CE marking. The declaration for this
machine (Figure 1.6) follows.
To Next Page
Loading...