TA3H, TA3SH & TA3.5SH Page 6 - 1
6. Initial Setup & Adjustments
6 Initial Setup & Adjustments
6.1 Delivery Checks
On delivery of the machine:-
• Remove any packaging and shipping supports.
• Release any transport locks.
• Clean any protective coating from bright metal parts.
• Check for damage and missing parts.
• Check all fluid levels.
• Check tyres are inflated to correct pressures.
6.2 Setup
Place the ROPS in the work position, Figure 6.1. refers.
Figure 6.1 - ROPS Set Up
1 Linch Pin
2 Locking Pin
bDANGER
The machine must not be used until the ROPS has been raised and secured in the work
position. It is prohibited to use a machine without the ROPS installed in the work position.
COV00029
2
1
To Next Page
Loading...