mecalac TA3SH - Recovery; Towing and Lifting Procedures

TA3H, TA3SH & TA3.5SH Page 11 - 1
11. Recovery
11. Recovery
11.1 Towing
The machine may be towed for short distances; see notice above, by attaching a suitable strap,
chain or rope to the rear towing eye of the machine or either or both of the tie down and recovery
eyes at the front of the machine. Take care if placing ropes etc. around the front axle as there is
a risk of damaging or deforming brake pipes or other components.
11.2 Lifting with a Crane
Refer to section 5 - Transportation for details of lifting the machine with a crane. It is important
that the articulation lock is fitted before lifting operations commence.
bCAUTION
With the engine dead the hydraulic system will not function, the steering will still operate but
under these circumstances steering wheel loads are high and the dumper must only be towed at
very slow speeds.
NOTICE
The machine may be towed at a maximum speed of 2km/h (1.2 mph) for a maximum distance of
1 km (0.6 miles). Exceeding this speed or distance may damage the pump, motor and hydraulic
system. Before the machine can be towed it is necessary to set the transmission pump to
“freewheel” mode. For instructions on this procedure refer to Section 8 - Emergency Operating
Procedures.