Page 12 - 2 TA3H, TA3SH & TA3.5SH
12. Storage, Decomissioning & Disposal
• Lubricate machine in accordance with lubrication diagram
• Examine tyres and inflate to correct pressure.
(a) If stored for more than a period of 6 months:-
• Replace hydraulic filters.
• Examine hydraulic oil for degradation and replace if necessary.
• Drain and replace oils in transfer box and axles.
12.4 Disposal
At the end of its life the machine must be disassembled by a competent person using safe
working practices, wearing the appropriate Personal Protective Equipment and working in
accordance with local regulations.
The appropriate lifting equipment, chocks and stands must be used to maintain a stable machine
as components are removed and the machines centre of mass changes.
Care must be taken when dealing with flammable liquids and the machine parts that contained
those liquids. Any process that could ignite flammable materials must not be used on
components that have contained flammable liquids in them or have residual flammable liquids
on them.
Fire extinguishers must be readily available if cutting/welding equipment is so used.
Fluids must be drained off into suitable containers and if possible recycled or otherwise disposed
of in an environmentally friendly way in accordance with local regulations.
Where possible recyclable materials must be separated out and processed in accordance with
local regulations using an authorised agent.
12.5 Disposal of Used Batteries
When the battery reaches the end of its usual life it must be removed from the machine and
recycled in an approved way in accordance with local environmental regulations.
This service is usually operated by battery vendors.
Machine users that cannot find a suitable battery recycling facility should contact Mecalac for
assistance.
To Next Page
Loading...
