mecalac TA3SH - Moving and Skip Operation

Page 7 - 6 TA3H, TA3SH & TA3.5SH
7. Standard Operating Procedures
7.6 To Stop the Engine
7.7 To Move the Machine
Refer to Figure 7.7
Figure 7.7. - Forward/Reverse and Fast Slow Switches
1. Forward Reverse Switch - A, Forward - B, Neutral - C, Reverse
2. Speed Switch - D, Fast - E, Slow
7.8 Loading the Skip
Before the skip is loaded the operator should:-
• Park the machine safely.
• Apply parking brake and stop engine.
• Get off the machine and stand clear.
PROCEDURE
1. Stop the machine in a safe position on firm level ground.
2. Apply parking brake and place the forward/reverse switch in Neutral.
3. Turn start key anticlockwise to OFF - position 0.
PROCEDURE
1. Make sure the parking brake is ON.
2. Make sure the forward/reverse switch in Neutral.
3. Start the engine.
4. Select Fast or Slow on the speed switch.
5. Select Forward or Reverse.
6. Release the parking brake.
7. Depress the accelerator pedal gently and the machine will begin to move.
8. Control the speed of the machine with the accelerator or brakes as required.
1
2
COV0022
6
A
B
C
D
E