TA3H, TA3SH & TA3.5SH Page 2 - 5
2. Safety
• Stop the engine before refuelling, if there is a spillage mop it up and do not start the engine
until it has been done.
• The exhaust gets extremely hot. Do not place anything on top of it and keep all combustible
materials clear. Do not attempt any maintenance on a hot engine.
• Check your local laws and regulations, the engine may require a spark arrester etc.
• Before performing any maintenance on the machine, place a warning tag on the machine to
prevent accidental start-up and remove the start key and battery isolator. Put the locking bar
into position to prevent the front and rear chassis moving and creating a crushing zone.
• Do not inspect or clean the machine with the engine running.
• Make sure all guards or shields are in place before using the machine.
• Before carrying out maintenance on the hydraulic system make sure the hydraulic fluid is cool
and there is no residual pressure in the hydraulic circuit - hydraulic fluid leaking under
pressure can penetrate the skin.
• Do not operate the machine if it is damaged, improperly adjusted or not completely and
correctly assembled.
• Keep footplates and steps free from dirt, oil, snow, ice etc.
• Do not remove the radiator cap when the engine is hot. Do not add coolant to a hot engine.
• Tyre changes and repairs to punctured tyres MUST only be carried out by fully trained
operatives using the correct equipment. The manufacturer of this machine recommends a
competent firm is employed to carry out these tasks.
Warnings about the work environment
• Be familiar with all prohibited work areas such as excessive slopes and dangerous terrain
conditions.
• Do not drive on slopes or gradients that exceed the safe limits stated for this machine in this
manual.
• If the machine is to be used on the public highway or at night lighting in accordance with
national requirements of the country concerned must be fitted.
• Always use driveways approved by site management when driving around the site.
• In the event of an electrical/lightening storm park the machine in a safe place, dismount and
seek shelter
• Always park machine correctly on firm, level ground where it will not cause an obstruction or
danger - chock the wheels if necessary. DO NOT LEAVE THE ENGINE RUNNING or the start
key in the start switch.
• Before taking the machine on public roads make sure that the machine complies with all road
traffic regulations and obey all driving laws.Warnings about using the Skip
• Do not work under a raised skip unless the props/supports are fitted and locked in position.
• Only fill skip with free flowing loads.
To Next Page
Loading...
