TA3H, TA3SH & TA3.5SH Page 9 - 11
9. Maintenance
(1) To Top Up the Cooling System
This operation must only be performed by topping-up the plastic expansion tank, Figure 9.11 to
maintain coolant level within the Full (Maximum) (2) and Add (Minimum) (3) marks on expansion
tank. The tank is accessible when the engine cover is open.
When topping-up the system, always check the water hoses for damage or wear and for any
obvious leaks.
Only fill the system via the radiator cap, after draining the system
.
Figure 9.11 - Cooling System Expansion Tank
1. Filler Cap
2. Full Mark
3. Add Mark
(2) Coolant
The coolant used to top up the cooling system must be a pre-mixed solution of antifreeze and
water in the correct ratio for the temperature range the machine is to be used in. See notes about
antifreeze in Antifreeze section.
NOTICE
Never over fill the expansion tank. Do not use anti leak additives in the cooling system. Never
run the engine without coolant in the system.
1
2
3
COV0005
To Next Page
Loading...
