Envoy 2 E Series User Guide 20190805-30.docx || © 2019 MegaVoice Ltd. || Page 43 of 68
Recording (Elite and Echo models only)
Overview
The Elite and Echo models of the Envoy 2 E Series provide the ability to make your own recordings. Details on
how to initiate recording mode and use the various features while in that mode are described in Recording
controls and features.
Recording files can be stored on both the onboard memory and microSD.
If a microSD card is present in the card reader when initiating recording mode, the player will default to it.
All recording files are created in WAV format (sample rate of 44,000 Hz, mono, Bit rate of 192 Kbps) and stored in
a special folder named “RECORD” in the root (onboard memory or microSD). The player will automatically create
this folder if it is not present.
The naming convention for the recorded files is “RECnnn.wav” where nnn is a 3-digit counter that the player
increments automatically beginning with 000. This allows for up to 1,000 files. The largest single file allowed is
2GB. Based on the settings described above, a 2GB file can contain about 23.7 hours of recorded audio.
To exit recording mode, you may change to audio playback mode (a 2-second press on the button), or to FM
Radio mode (a 2-second press on the button; Elite and Equip only) or turn the player off completely. If a
recording is in progress when leaving Recording mode, the file will be saved “as is” before exiting (some
truncation may occur).
When recording to a microSD card, do NOT remove the card while recording is in progress. This will result
in a corrupt file and you will lose your work. The player will beep 4 times to alert you and stop recording.
See potential issue after using Recording mode.
To Next Page
Loading...
