Envoy 2 E Series User Guide 20190805-30.docx || © 2019 MegaVoice Ltd. || Page 58 of 68
Audio playback bookmark
Setting the bookmark
During audio playback, a 2-second press on the pause button will place a bookmark at the current position.
The player will beep 3 times to confirm and place the player in pause mode (see Buttons for navigating the
Current Chapter, the Pause button).
When the player is turned back on later, it will always begin to play from this bookmark. This bookmark will
persist until:
It is removed by the user (see below)
Or it is reset to a different place in the audio
The Envoy 2 E Series player supports 2 audio playback bookmarks – a permanent (explicit) one (that may
be set by the user by using the instructions above) and a temporary (implicit) one (which is managed internally by
the player).
When switching from Audio Playback mode to another mode the temporary bookmark is always set.
When returning to Audio Playback mode from another mode, the temporary bookmark will be used as the point
from which to resume playback.
When turning the player on, the user-set bookmark is used for resumption of playback.
Resetting the bookmark to the beginning
To reset the bookmark to the beginning of the audio message, follow these steps:
1. During audio playback, click the pause button .
2. Once the player is paused, press the volume up button on the keypad for 2 seconds. The player will
beep once to confirm.
3. The bookmark is now reset to the beginning of the audio message.
4. You may resume playback or turn the player off .
To Next Page
Loading...
