Envoy 2 E Series User Guide 20190805-30.docx || © 2019 MegaVoice Ltd. || Page 56 of 68
Battery care and charging
With proper care, the player’s Lithium-Ion battery should perform well for several years. When shipped, the
battery is only partially charged. You can easily charge the player using one of the methods below:
For fastest charge, connect any standard “USB” charger (regulated +5VDC, minimum 300mA) to the micro-
USB port on the bottom of the player for about 2 hours* or until the LED stops blinking. While charging, the LED
will blink according to the charge level described above.
Plug the player into any standard computer USB port using a “USB to micro-USB” cable for about 3 hours* or
until the LED stops blinking. Any MegaVoice SLS, regular or charge-only cable is sufficient.
For solar charging, place the player with the solar panel** facing bright sunlight for at least 8 hours* (there is
no indication during solar charging).
*Actual charge time will vary according to the current battery capacity.
**Some versions of the Envoy 2 E do not include a solar panel.
Before storing the player for prolonged periods, make sure the battery is at least partially charged. If stored for
extended periods, it is recommended to recharge the player at least every 6 months in order to prevent the
battery from losing its ability to charge. For optimum battery life, try to store the player at room temperature or
cooler.
Should the battery become damaged and unable to accept a charge, you can still operate the player by either
connecting it to a computer with any micro-USB cable or to an electric wall charger.
To Next Page
Loading...
