SECTION 5
DISASSEMBLY AND ASSEMBLY
108
14. Slide the Latch Lever Spring onto the Latch Pin, then
slide the Latch Lever for that side onto the Pin. Repeat
the procedure for the other side.
15. Maneuver the spring so the upper arm fits under the tab
on the Side Frame. The lower spring arm fits over the
tab on the Latch Lever.
NOTE: This can be tricky, you may require two
small flat blade screwdrivers or other tools to snap
the lower spring end over the Lever tab. Repeat
procedure for the other side.
16. Reinstall the C-clip that secures the Latch Lever to the
Upper Latch Pin. Repeat procedure for the other side.
17. Replace the two cable ties that secure the wire harness
to the Crossmember (removed in Step 5.) Trim excess.
To Next Page
Loading...
