Mercury 40 Service Manual

IGNITION
Page 2A-20 90-828631R3 MARCH 1999
Flywheel Installation
1. Place flywheel key into slot.
2. Install flywheel.
3. Hold flywheel using flywheel holder (91-83163M). Apply oil to threads on crankshaft and
tighten nut to the specified torque.
FLYWHEEL WITHOUT LOAD RING & SPACER
53278
a
b
c
d
a-Flywheel Key
b-Washer
c-Nut
d-Apply Oil to Threads
Flywheel Nut Torque
116 lb-ft (157 Nm)

Mercury 40 Specifications

General

Horsepower	40 hp
Starting System	Electric
Steering	Remote
Fuel Induction System	EFI (Electronic Fuel Injection)
Shaft Length	20"
Full Throttle RPM Range	6000