Section 5 - Maintenance
Page 94 90-866938081 MAY 2009
2. Fill the gear lube monitor with the specified gear lube so that the gear lube is level with
the "COLD FILL LEVEL" line (cold full line). Do not overfill.
"COLD FILL LEVEL" line (cold full line)
Tube Ref No. Description Where Used Part No.
82
Premium Gear Lubricant
Gear housing and gear lube
monitor during break-in (the
first 25 hours but not to exceed
30 hours of operation)
92-858058K01
Tube Ref No. Description Where Used Part No.
87
High Performance Gear Lube
Gear housing and gear lube
monitor after break-in (after the
first 25–30 hours of operation)
92-858064K01
3. Ensure that the rubber gasket is inside the cap for the gear lube monitor and install the
cap. Do not overtighten.
NOTE: After the drive has been operated and the gear lube is hot, the fluid expands and
may be up to the "MAX OPERATING LEVEL" line (hot full line).
"MAX OPERATING LEVEL" line (hot full line)
Changing
WITH THE BOAT IN THE WATER
NOTE: Change the drive gear lubricant when the drive is at operating temperature. Warmer
lubricant flows more freely, carries away more impurities, and is easier to remove from the
drive.
1. Place oil‑absorbent wipes or material around the area to contain any spilled lubricant.
To Next Page
Loading...
