EasyManuals Logo

Mercury Zeus 3000 Series User Manual

Mercury Zeus 3000 Series
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
Section 3 - On the Water
90-866938081 MAY 2009 Page 35
NORMAL STOPPING
1. Move the ERC handles to the neutral position.
2. Corresponding to the engine you want to stop, and depending on your equipment, do
one of the following:
Press and release the "START/STOP" switch, if equipped with optional SmartStart
switch panel. Then, turn the respective key switch to the off position.
Turn the respective key switch to the off position for each engine stopped.
3. After stopping the engines you may close the seacocks. Rotate the handles in the
direction indicated by the arrows.
a
b
41199
Drive cover removed for clarity
a - Seacock for seawater return
b - Handle in closed position
a
c
b
41196
Typical inlet seacock—port orientation
a - Seacock for seawater inlet
b - Former position (open)
c - Handle in closed position
STARTING AN ENGINE USING THE VIP SMARTSTART SWITCH
You may desire to start an engine from the engine room or under certain circumstances
the engine control systems may not be able to automatically start an engine. The engines
can be started using the "SMARTSTART" (stop/start) switch on the VIP for each engine.
1. Perform the drive checks listed in Section 5-Routine Maintenance, Each Day Start
and When Refueling.
2. Perform the checks and steps listed in the engine's operation and maintenance manual
available for this package.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury Zeus 3000 Series and is the answer not in the manual?

Mercury Zeus 3000 Series Specifications

General IconGeneral
BrandMercury
ModelZeus 3000 Series
CategoryEngine
LanguageEnglish

Related product manuals