Section 3 - On the Water
Page 36 90-866938081 MAY 2009
3. Open the seacock for the seawater return. Rotate the handle in the direction indicated
by the arrow.
Drive cover removed for clarity
a - Handle in open position
b - Seawater return (overboard) seacock
4. Open the seacock for the seawater inlet. Rotate the handle in the direction indicated
by the arrow.
Typical inlet seacock—port orientation
a - Seacock for seawater inlet
b - Handle in open position
c - Former position (closed)
5. Open the seacock (if equipped) for any accessory equipment.
NOTE: When the key switch is turned to the on position the neutral LED lights, on the ERC
trackpad, flash on and off if the ERC handles are not in the neutral position. Before starting
the engines the ERC handles must be in neutral position, as indicated by the neutral
indicator lights on continuously.
6. Move the ERC handles to the neutral position.
NOTE: Ask your dealer for the location of the key switches if the key switches are not
located at the helm.
7. Turn the key switch to the on position for each engine to be started.
8. Verify it is safe to start the engines.
9. In the engine room, locate the VIP for each engine.
To Next Page
Loading...
Need help?
General