Section 5 - Maintenance
90-866938081 MAY 2009 Page 119
5. Install the driveshaft shield on the engine end using the flange‑head screws as
shown. Tighten the screws to specification.
a - Top shield
b - Driveshaft shield to engine screw
c - Engine end
Description Nm lb. in. lb. ft.
Driveshaft shield screw—engine end 36 – 27
Driveshaft U‑Joints
NOTE: In addition to the task and interval for inspecting and lubricating the driveshaft
U‑joints every 250 hours or one year (whichever occurs first), you must replace the U‑joints
every 1000 hours or two years (whichever occurs first) . Contact your Cummins MerCruiser
Diesel Repair Facility for information on the nearest driveshaft service location.
1. Remove the driveshaft shield on the engine end.
a - Driveshaft shield
b - Screw (two on each side)
c - Engine end
To Next Page
Loading...
